Reactor spools up to 2350kw to meet the static load. The reactor typically sits at 2350kw and the batteries can provide a combined 1500kw for short periods of time. This submarine also contains a reactor and 2 batteries. In practice this tends to be somewhat lower due to how they respond to demand and charge. This is a list of common devices on a submarine that can contribute power. Such a sub would have a dynamic load of 2900kw. Ignore the deconstructor and fabricator because their power consumption is short and rare. Use varies significantly.Īssume further that this submarine has an engine and 3 pumps. This is a list of common devices on a submarine that have significantly varying power consumption. Such a sub would have a static load of 2350kw. Usually left on.Īssume a submarine with a minimap, oxygen generator, 2 sonar monitors, 2 batteries, and 10 lamps. This is a list of common devices on a submarine that have a constant or nearly constant power consumption. Always keep in mind the difference between static (constant) load and dynamic (changing) load: static is safe, dynamic is dangerous. Crew will use power according to their immediate needs and this must be accounted for. Crew do not usually coordinate power usage as there are almost always more immediately vital tasks to perform. Understanding what causes voltage to change is key to designing a robust power network.Ĭonsider the different devices on a submarine and how they are typically used. Power is significantly more restricted as the reactor can only adjust so quickly. Load can shift up and down very rapidly as devices turn on, off, or vary their output. The challenge in providing a stable voltage is that power and load change over time. Low levels cause erratic function or even no function at all, while high levels short out junction boxes and thus cause a total loss of voltage. The primary purpose of a power network is to provide a stable level of voltage. This section will cover what to consider when designing a submarine and solutions to common problems. The editor tutorial describes how to place and wire submarine components.
0 Comments
Leave a Reply. |